How to change the touch screen on your Tablet?

In the context of technological development, the use of electronic products has long been mainstream. Today, let's talk about how to replace the screen of an electronic product. It may sound fancy, but in fact, it's very easy to operate! As long as you follow my steps, it can be done in minutes.
 

Firstly, some preparation work needs to be done, and the specific list of tools to be used is as follows
1. You need a set of repair tools, including suction cups, pry bars, screwdrivers, etc. You can choose to purchase them online or in physical stores offline.
2. Prepare the new screen that needs to be replaced in advance, and recommend using our original quality screen from Xinlilai. The quality is good, the price is affordable, and the display effect is excellent!
3. Find a clean and bright place and prepare a clean container to install and remove the parts, which can avoid the loss of small parts.
 

After preparing the tools, the next step is to proceed to the replacement process. Please be careful to minimize accidents.
1. Shut down and remove the SIM card: This step is very important, don't be lazy!
2. Heat the screen edge: Use a hair dryer or hot air gun to heat the screen edge for 1-2 minutes to soften the glue.
3. Suction cup pulls up the screen: Gently use the suction cup to pull up a corner of the screen, being careful not to apply too much force.
4. Separate the screen: Use a pry bar to slowly cut open the adhesive between the screen and the body, being careful not to damage the wiring.
 

Finally, install a new screen to your device.
1. Clean up residual glue: Use an alcohol swab to clean the remaining glue on the machine body.
2. Connect the ribbon cable: Insert the ribbon cable of the new screen into the motherboard interface and remember to lock it tightly!
3. Test screen: Power on and test whether the display and touch are normal.
4. Fixing the screen: Apply special glue to the edge of the screen, align it with the position, and gently press to fix it. After fixing, let it sit for 3-5 minutes until the glue dries completely.